克里米亞剛果出血熱病毒熒光PCR檢測試劑盒

廣州健侖生物科技有限公司

One tube multiplex for detection of Crimean Congo haemorrhagic fever virus and internal control.

單管多重檢測克里米亞剛果出血熱病毒和內部控制。

克里米亞剛果出血熱病毒熒光PCR檢測試劑盒

我司還提供其它進口或國產試劑盒：登革熱、瘧疾、流感、A鏈球菌、合胞病毒、腮病毒、乙腦、寨卡、黃熱病、基孔肯雅熱、克錐蟲病、違禁品濫用、肺炎球菌、軍團菌、化妝品檢測、食品安全檢測等試劑盒以及日本生研細菌分型診斷血清、德國SiFin診斷血清、丹麥SSI診斷血清等產品。

歡迎咨詢

歡迎咨詢2042552662

想了解更多的產品及服務請掃描下方二維碼：

【公司名稱】 廣州健侖生物科技有限公司
【市場部】    楊永漢

【】 
【騰訊  】 2042552662
【公司地址】 廣州清華科技園創新基地番禺石樓鎮創啟路63號二期2幢101-103室

7、顏色改變單位法（colour change unit,簡稱CCU）
這種方法通常用于很小，用一般的比濁法無法計數的微生物，比如支原體等，因為支原體的液體培養物是*透明的，呈現為清亮透明紅色，因此無法用比濁法來計數，由于支原體固體培養很困難，用cfu法也不容易計數，因此需要用特殊的計數方法，即CCU法。它是以微生物在培養基中的代謝活力為指標，來計數微生物的相對含量的，下面以解脲脲原體為例，簡單介紹其操作：
（1）.取12只無菌試管，每一管裝1.8ml解脲脲原體培養基。
（2）.在*管加入0.2ml待測解脲脲原體菌液，充分混勻，從中吸取0.2ml加入第二管，依次類推，10倍梯度稀釋，一直到zui末一管
（3）.于37度培養，以培養基顏色改變的zui末一管作為待測菌液的CCU，也就是支原體的zui大代謝活力，比如第六管出現顏色改變，他的相對濃度就是10的6次方CCU/ml.
一般來說，比濁法和菌落計數法就可以滿足絕大多數細菌的計數，但是對支原體這樣比較特殊的微生物，用CCU法比較合適。
1.1.常量肉湯稀釋法
1.1.1.抗菌藥物貯存液制備 抗菌藥物貯存液濃度不應低于1000μg/ml(如1280μg/ml)或10倍于zui高測定濃度。溶解度低的抗菌藥物可稍低于上述濃度。抗菌藥物直接購自廠商或相關機構。所需抗菌藥物溶液量或粉劑量可公式進行計算。例如：需配制100 ml濃度為1280μg/ml的抗生素貯存液，所用抗生素為粉劑，其藥物的有效力為750μg/mg。用分析天平精確稱取抗生素粉劑的量為182.6 mg。根據公式計算所需稀釋劑用量為：（182.6 mg×750μg/ml）/1280μg/ml=107.0ml，然后將182.6 mg抗生素粉劑溶解于107.0ml稀釋劑中。制備抗菌藥物貯存液所用的溶劑和稀釋劑見表5。配制好的抗菌藥物貯存液應貯存于-60℃以下環境，保存期不超過6個月。
1.1.2.藥敏試驗用抗菌藥物濃度范圍 根據NCCLS抗菌藥物敏感性試驗操作標準，藥物濃度范圍應包含耐藥、中介和敏感分界點值，特殊情況例外。

7, color change unit method (color change unit, referred to as CCU)
This method is generally applied to microorganisms such as mycoplasma which can not be counted by the ordinary turbidimetry because liquid cultures of mycoplasma are compley transparent and clear and bright red and thus can not be counted by turbidimetry. Because mycoplasma solid culture is very difficult to use cfu method is not easy to count, so the need for a special counting method, that CCU method. It is the microbial metabolic activity in the medium as an indicator to count the relative content of microorganisms, the following Ureaplasma urealyticum, for example, a brief description of its operation:
(1) Take 12 sterile tubes, each tube 1.8ml Ureaplasma urealyticum medium.
(2) 0.2 ml of the Ureaplasma urealyticum solution to be tested is added into the first tube, thoroughly mixed, and 0.2 ml of the Ureaplasma urealyticum is taken into the second tube, followed by a 10-fold gradient dilution until the last tube
(3) at 37 degrees Celsius, the last tube with color change medium as the test bacteria CCU, which is the maximum metabolic activity of mycoplasma, such as the sixth tube appears color change, his relative concentration is 10 6th CCU / ml.
In general, turbidimetry and colony counting method can meet the count of most bacteria, but for mycoplasma such a more specific microorganism, CCU method is more appropriate.
1.1. Constant broth dilution method
1.1.1. Antimicrobial Drug Stock Solutions Antibacterial stock solutions should be prepared at a concentration of no less than 1000 μg / ml (eg 1280 μg / ml) or 10 times the highest measured concentration. Antibacterial drugs with low solubility may be slightly lower than the above concentration. Antimicrobials are purchased directly from manufacturers or related agencies. The required amount of antibacterial solution or powder dosage can be calculated formula. For example, prepare 100 ml of antibiotic stock solution at a concentration of 1280 μg / ml. The antibiotic used is a powder and the potency of the drug is 750 μg / mg. The exact amount of antibiotic powder weighed with the analytical balance was 182.6 mg. Calculate the required amount of diluent according to the formula: (182.6 mg x 750 μg / ml) /1280μg/ml=107.0ml, then dissolve 182.6 mg of antibiotic powder in 107.0 ml of diluent. Table 5 shows the solvents and diluents used to prepare antimicrobial stock solutions. Preparation of a good antibacterial drug storage solution should be stored in the environment below -60 ℃, shelf life of not more than 6 months.
1.1.2. Range of Antimicrobials for Susceptibility Testing According to the NCCLS Antimicrobial Sensitivity Test Operating Standard, the drug concentration range should include values ??for resistance, mediation and sensitive cutoff points, with special exceptions.